Welcome to Zhenjiang Winfar Transport Facilities Co.,Ltd.!
E-mail:Estelle@winfarroad.com   TEL:86-18762328320
Home >> News >> How to Use YHTQ-Z Self-propelled Thermoplastic Convex Road Marking Machine

How to Use YHTQ-Z Self-propelled Thermoplastic Convex Road Marking Machine

Sep 29,2016

1. Preparation before operate YHTQ-Z self-propelled convex road marking machine

(1) Check whether all the coupling bolts of each component are tightened, whether the gas pipeline leak, whether the spare parts of convex road marking machine are damaged.

(2) Fire the fire gun, heating the paints tank with small fire, and heating the road marking shoe with middle fire, when the convex thermoplastic paints in the road marking shoe is softened, clean the marking shoe and spray oil to the various parts, and check whether the discharge handle is free.

(3) Pull out and fix the warning light pole in order to exhaust smooth before starting the Honda gasoline engine. Push the driving clutch handle to “Separation”, place the speed control handle to “Stop”, turn the glass beads dispenser clutch handle to “Off”, and turn the total power switch of the controller to “Off”.

(4) Start the gasoline engine, after 3 minutes of idling, close the air tank exhaust valve, observe whether the gasoline engine and air pump operation are normal, whether the pressure of the air tank reaches the working pressure.

(5) Open the total power switch of the controller, check whether the speed indicator light is normal, according to the aforementioned control panel operation method to operate and set the value of debugging, and adjust the line guide to prepare marking lines.

2. YHTQ-Z self-propelled convex road marking machine Operation Process

(1) Pour the melted convex thermoplastic paints from the thermoplastic pre-heater into paints tank, and the paints should be stirring often, in order to avoid precipitation and burnt.

(2) Keep the line guide, pre-marking line and convex road marking machine in one line, let paints flow into the marking shoe by open the discharge gate, put the marking shoe down road surface, then turn the “Auto Mark” on, and push the driving clutch handle to “Reunion”, push forward the speed control handle, then the road marking machine moves, then press down the marking shoe discharge handle, and push forward the glass bead dispenser clutch hanle, the machine starts to mark lines.

Attention: in order to ensure the line is convex, marking speed shouldn’t be too fast. Lift the handle to close the hopper discharge door, and lift the road marking shoe to the car’s frame, close the glass bead dispenser, turn off the “Auto Mark”, then move the raised line marking machine to the next work site, after finishing marking part of the road.

(3) The convex thrmoplastic paints can be poured into the road marking shoe at any time when marking lines.

(4) Discharge the compressed gas in the gas tank, turn off the total power, and push the driving clutch handle to “separation”, transfer the speed control handle to “Stop”, and turn the glass beads dispenser clutch handle “Off”, the remaining paints in the road marking shoe should be as little as possible, and turn off all the gas switch after finishing the road marking work.


© Copyright 2014 Winfar All Rights Reserved.